Custom LED Light Bar Build (Part 1 "Project Night Light")

Опубликовано 31 марта 2015, 6:00

Join me in building a custom LED light bar mount for my truck. I start with a drawing and some pieces of metal and make it into a fully functional rig to hold my 42in LED Light Bar. The rack consists of bed rails, a headache rack, and a roof rack, all-in-one, to hold the light bar. I use 1.5in .083 wall square tubing, a 90amp harbor freight flux welder, a grinder, and a cutoff wheel to get the job done.

Episode 2: youtube.com/watch?v=Amc-BfSh25...
Episode 3 (wiring the lights): youtube.com/watch?v=b8GY69Ci7l...

Here is where I got the 42in Wurton lightbar: amazon.com/gp/product/B00KQHHL...
Welder I used to make my rig: amzn.to/2vpDKc6
Grinder I used: amazon.com/gp/product/B0015Z5G...
Cutoff Wheel I used: amazon.com/gp/product/B0064UQO...

**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. New videos every Thursday**

-Website: ChrisFixed.com
-Facebook: facebook.com/chrisfix8
-Twitter: twitter.com/ChrisFixed
-Instagram: instagram.com/chrisfixit
-Subscribe Here: youtube.com/subscription_cente...
-YouTube Channel: youtube.com/ChrisFix

Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.