How To Tighten Ball Joints That Just Spin - EricTheCarGuy

586 853
38.5
EricTheCarGuy1.81 млн
Опубликовано 10 августа 2012, 11:29
How To Tighten Ball Joints That Just Spin - EricTheCarGuy

How to tighten ball joints also works with tie rod ends or any other suspension part similar in design. The trick is to put the stud in a bind so that you can catch some threads, once you've done that and the fastener starts to tighten you can loosen up your 'wedge' and tighten it up the rest of the way.

I get asked about this a lot and hope you find this to be a good solution to this problem.

Visit me at: ericthecarguy.com

---

Click below and Stay Dirty

Visit me at EricTheCarGuy.com
ericthecarguy.com

Visit EricTheCarGuy Forum
ericthecarguy.com/forum/defaul...

Visit my Facebook Page:
facebook.com/EricTheCarGuy

---

Stay dirty

ETCG

Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
автотехномузыкадетское