Replacing A Hydroboost Unit - EricTheCarGuy

Опубликовано 7 декабря 2010, 1:54

Replacing A Hydroboost Unit - EricTheCarGuy

ericthecarguy.com
This is actually the first one of these that I replaced, it's a little more complicated than a regular vacuum booster but not by much. I looked up the procedure for installing the system and it said to crank the engine without starting it, if I were to do it again I'm not sure I would bother with this because the fluid didn't seem to flow until I revved the engine past 2500, once I did this things started to work normally.

---

Click below and Stay Dirty

Visit me at EricTheCarGuy.com
ericthecarguy.com

Visit EricTheCarGuy Forum
ericthecarguy.com/forum/defaul...

Visit my Facebook Page:
facebook.com/EricTheCarGuy

---

ETCG

Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.