How To Replace A Window Run Channel ( 97 Honda Accord) - EricTheCarGuy

Опубликовано 5 июня 2011, 17:33

How To Replace A Window Run Channel ( 97 Honda Accord) - EricTheCarGuy

ericthecarguy.com

You would normally be doing this if you had an issue with wind noise or a problem with the window going up and down that did not involve the regular/motor assembly. This is pretty much the same procedure for doing a window motor/regulator assembly, there are just a couple of extra steps you take to remove the motor after removing the window.

---

Click below and Stay Dirty

Visit me at EricTheCarGuy.com
ericthecarguy.com

Visit EricTheCarGuy Forum
ericthecarguy.com/forum/defaul...

Visit my Facebook Page:
facebook.com/EricTheCarGuy

---

Stay dirty

ETCG

Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information.  EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video.  Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result.  Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.